| | | | |
![](act_origtop_e.gif) |
![](clear.gif) |
![](act_origtrybutton_e.gif) |
![](clear.gif) |
Nokki
Start with a square piece of paper at least 6 inches across. It should be different colors on the two sides, preferably orange and green. Also, get a piece of yellow paper, some glue or paste, and a black crayon! |
![](nokki/nokki_1.gif) |
Fold the paper in half diagonally, and unfold. |
Fold the two edges to the center crease. |
![](nokki/nokki_2.gif) |
![](nokki/nokki_3.gif) |
Fold the bottom point behind the model, lining up with the corners of the flaps made in step 2. |
Fold the long point down so it ends up halfway down the green area, and unfold |
![](nokki/nokki_4.gif) |
![](nokki/nokki_5.gif) |
Fold the two side corners behind the model |
Fold the two corners in the middle up and out to form the wings. |
![](nokki/nokki_6.gif) |
![](nokki/nokki_7.gif) |
Fold the top point down using the crease from step 4. |
Fold the point back up again as shown. |
![](nokki/nokki_8.gif) |
![](nokki/nokki_9.gif) |
Fold the long point back down at a bit of an angle. |
Pull out some paper from under the beak. (You can skip this step if it is too hard.) |
![](nokki/nokki_10.gif) |
![](nokki/nokki_11.gif) |
Pinch the top corners to form the "ears". |
Draw on the face and glue on the big yellow eyes. You're all done! |
![](nokki/nokki_13.gif) |
![](act_origtrybutton_e.gif) |
![](act_origbottom_e.gif) |
Origami designs by Joseph Wu. Joseph Wu is webmaster of The Origami Page and a member of the Japanese Origami associations Origami Tantei Dan and Nippon Origami Association.
|